CNC Lathe Machining- No Ball Screws!

by admin on June 21, 2009

Actual Machining time: 40 minutes + 10 minutes polishing. No ball screws!

Automate your lathe today with Putnam Engineering!

Duration : 0:3:47

{ 4 comments… read them below or add one }

kakadikui June 21, 2009 at 9:34 am: what a performance! …
what a performance! awesome
BlindedByEvil June 21, 2009 at 9:34 am: dam thats fast will …
dam thats fast will a nice finish and the treading
teqdruid June 21, 2009 at 9:34 am: We’ve got an …
We’ve got an automatic mode that was used to make this part. Turns out that it’s easier to set it to run 50 passes at a low depth and get a cup of coffee than to vary the cut depth. Using a small advance is also very important for the first few passes on the ball- exponentially less important as you move on.
latheworks June 21, 2009 at 9:34 am: Wow, all those cuts …
Wow, all those cuts! Can’t imagine the state of the lathe bed in about a years time! I think that a review on the depth of cut is called for. If you have build a Quorn, you might as well go nuts right off the bat. Other than taht, very impressive result, yes Sir! Liked the QCTP too!
Thanks for uploading this. Keep it up!